Switching Reports On/Off - Ricoh 170 / 180 Operator's Manual

SWITCHING REPORTS ON/OFF

Power Failure Report (Type I Only)
This report is printed if the machine's power was off long enough to erase the
memory. The report gives details of the files that were lost. With this information,
you may store messages for transmission again, and contact the senders of any
received messages that were lost.
Polling Clear Report (Type I Model)
This is printed after a polling file has been erased from memory.
SWITCHING REPORTS ON/OFF
Some of these reports can be switched on or off. To switch a report on or off, do
the following (see page 102 if you need more information about User Parameter
settings adjustment procedure).
1. Press the Function key and
6,2,2,2,2,6,3 using the ten keypad, then
press the Yes key.
2. Press the Yes key. The settings for
Switch 00 are now displayed.
3. Press the
and
j
for Switch 03 are displayed.Each digit
from 0 to 7(except digit 1) controls a re-
port.
Switch 03
Digit
Communication Result Report
0
(Type I Only)
1 Do not change this setting.
File Reserve Report
2
(Type I Only)
3 File Reserve Report
Communication Result Report
4
Transmission Result Report
5
(Immediate Transmission)
6 Polling Clear Report (Type I Only)
7 TCR
86
keys until the settings
k
(Memory Transmission)
(Polling Reception)
Purpose
(Memory Transmission)
0: Off
0: Off
0: Off
(Polling Recption)
0: Off
0: Off
0: Off
0: Off
j
j
j k
j k
1: On
1: On
1: On
1: On
1: On
1: On
1: On