Cellular Module And Sim Installation - Visonic PowerMaster-33 G2 Installer's Manual

3.5 Cellular Module and SIM Installation

Review Figure 3.1.1.or 3.1.2 depending on the configuration.
Plug in the Cellular module and fasten it as shown in the above
drawing making sure that the two leading slots on both sides of
the Cellular module slide along the two leading ribs on the front
unit.
A. Cellular module
B. Leading ribs
C. Leading slot (1 of 2)
D. Front panel
Caution! Do not install or remove the Cellular module when the
system is powered by AC power or backup battery.
Figure
12
3.5 – Optional Cellular Module Mounting and SIM Card Insertion
To install the cellular external antenna,
complete the following steps:

Mount the optional cellular external
antenna on the required site surface.

Connect the connector to the internal
cellular module and insert the SIM card.
Note:
To remove the external antenna if required, hold
the connector and pull it out.
Do not attempt to remove the antenna by holding the
cable.
Insert the SIM card into the Cellular module as shown
in the above drawing.
1. Slide top cover.
2. Open cover
3. Align SIM card in cover (note cover orientation)
4. Slide SIM card into cover
5. Rotate cover to close
6. Lock cover to close
IMPORTANT! Do not insert or remove SIM card when
the control panel is powered by AC power or battery.
D-306917
PowerMaster-33 G2 Installer's Guide