Table of Contents
Advertisement
3
If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
4
If applicable, disconnect the power or data cables from expansion card(s).
Steps
1
Locate the battery socket. For more information, see the
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or removing a
battery.
2
Use a plastic scribe to pry out the system battery.
Figure 96. Removing the system battery
3
To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4
Press the battery into the connector until it snaps into place.
Figure 97. Installing the system battery
Next steps
1
Installing the expansion card riser
2
If applicable, connect the cables to the expansion card(s).
3
If applicable, open the PCIe card holder latch on the air shroud to secure the full length expansion card.
4
Follow the procedure listed in
5
While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
6
Enter the correct time and date in the System Setup Time and Date fields.
7
Exit the System Setup.
Identifier
Status
Power supply units
The power supply unit (PSU) is an internal hardware component which supplies power to the components in the system.
Your system supports 1100 W and 750 W AC power supply units (PSUs).
144
Installing and removing system components
1.
After working inside your
system.
GUID-109C6962-A67D-4618-99C9-1B6169E19CA6
Released
System board jumpers and connectors
section.
Hide quick links:
Advertisement
Table of Contents
