Removing The Expansion Card From The Expansion Card Riser - Dell EMC NX3240 Installation And Service Manual

Figure 61. Closing the PCIe card holder latch
Next step
Follow the procedure listed in
Identifier
Status

Removing the expansion card from the expansion card riser

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 If applicable, remove the air
4 If applicable, disconnect the cables from the expansion card.
5 When removing a card from riser 2 or 3, ensure that the PCIe card holder latch is closed.
Steps
1 Pull the expansion card latch out of the slot.
2 Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
116 Installing and removing system components
After working inside your system.
GUID-EB73D840-D434-4901-9B14-B3935FF87EA9
Released
Safety instructions.
Before working inside your
shroud.
system.