Mid Drive Tray; Removing The Mid Drive Tray - Dell EMC NX3240 Installation And Service Manual

Figure 28. Installing an intrusion switch
Next steps
1 Install the cooling fan
2 Follow the procedure listed in
Identifier
Status

Mid drive tray

The mid drive tray is located behind the cooling fan assembly. It supports up to 4 x 3.5-inch drives.
NOTE: Systems that support the internal mid drive tray require low-profile heat sinks and do not require or support an air shroud.
This section contains information about the removal and installation of the mid drive tray, drive blank from drive carrier, drive carrier from
the mid drive tray, and 3.5-inch drive from the drive carrier.
Identifier
Status

Removing the mid drive tray

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Disconnect all the cables from the drive backplane.
CAUTION: The drive tray is hot to touch for some time after the system has been powered down. Allow time for the drive
tray to cool before handling it.
80 Installing and removing system components
assembly.
After working inside your
GUID-2DA2A721-DDAF-4BC5-8AD9-5ADB25CABBE3
Released
GUID-A02F3DBE-B678-42CC-A63A-1B11E9ABA43B
Released
Safety instructions.
Before working inside your
system.
system.