Running The Embedded System Diagnostics From The Dell Lifecycle Controller; System Diagnostic Controls - Dell EMC NX3240 Installation And Service Manual

Identifier
Status
Running the Embedded System Diagnostics from the Dell
Lifecycle Controller
1 As the system boots, press F10.
2 Select Hardware Diagnostics → Run Hardware Diagnostics.
The ePSA Pre-boot System Assessment window is displayed, listing all devices detected in the system. The diagnostics starts
executing the tests on all the detected devices.
Identifier
Status

System diagnostic controls

Menu Description
Configuration Displays the configuration and status information of all detected devices.
Results Displays the results of all tests that are run.
System health Provides the current overview of the system performance.
Event log Displays a time-stamped log of the results of all tests run on the system. This is displayed if at least one event
description is recorded.
160 Using system diagnostics
GUID-6206A58E-097E-4CBF-B231-24AECA7C1C98
Released
GUID-8D6EDBD6-EBD4-492F-9534-8430B25CEC3E
Released