After Working Inside Your System; Recommended Tools; Front Bezel; Removing The Front Bezel - Dell EMC NX3240 Installation And Service Manual

Identifier
Status

After working inside your system

Prerequisite
Follow the safety guidelines listed in
Steps
1 Install the system cover.
2 If applicable, install the system into the rack.
For more information, see the Rack Installation Guide at Dell.com/storagemanuals.
3 Reconnect the peripherals and connect the system to the electrical outlet.
4 Turn on the attached peripherals and then turn on the system.
Identifier
Status

Recommended tools

You need the following tools to perform the removal and installation procedures:
• Key to the bezel lock
• Phillips #1 screwdriver
• Phillips #2 screwdriver
• Torx #T30 screwdriver
• Torx #T8 screwdriver
• Wrist grounding strap
Identifier
Status

Front bezel

A lock on the bezel is used to protect unauthorized access to the drives with LCD panel. For more information, see
The LCD bezel is hot pluggable and can be used in any NAS system of the same branding even if that system was originally not ordered
with that LCD bezel.
This section contains information about the removal and installation of the front bezel.
Identifier
Status

Removing the front bezel

Prerequisite
Follow the safety guidelines listed in
64 Installing and removing system components
GUID-652FF3C2-D45E-43E3-8CFE-57E719691227
Released
Safety instructions.
GUID-DA198690-4999-4F6B-A0B5-27AFB5483775
Released
GUID-1802497D-DBCA-4FEA-8DDB-31FB1B783A33
Released
GUID-FCEFAAAA-EF7B-43A3-A0AE-FEB6688C0683
Released
Safety instructions.
LCD panel.