Figure 87. Installing the backplane
Next steps
1
Connect all the cables to the backplane.
2
Install all the drives.
3
Install the backplane cover.
4
Install the
cooling fan
5
Install the
air
shroud.
6
Follow the procedure listed in
Identifier
Status
Removing the mid drive backplane
The procedure to remove the backplane is identical for 2.5-inch and 3.5-inch configurations.
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before removing the
backplane.
CAUTION:
You must note the number of each drive and temporarily label them before removal so that you can replace them in
the same locations.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove all the drive carriers from the mid drive tray.
4
Disconnect all the cables from the backplane.
Step
Press the release tabs and lift the backplane out of the drive tray.
136
Installing and removing system components
assembly.
After working inside your
GUID-760D83AE-4207-4EED-A411-8A4C6E9168FA
Released
Safety
instructions.
Before working inside your
system.
system.