Boot Manager; Viewing Boot Manager; Boot Manager Main Menu - Dell EMC NX3240 Installation And Service Manual

For more information about setting up the Dell Lifecycle Controller, configuring hardware and firmware, and deploying the operating system,
see the Dell Lifecycle Controller documentation at Dell.com/idracmanuals.
Identifier
Status

Boot Manager

The Boot Manager screen enables you to select boot options and diagnostic utilities.
Identifier
Status

Viewing Boot Manager

About this task
To enter Boot Manager:
Steps
1 Turn on, or restart your system.
Enter the result of your step here (optional).
2 Press F11 when you see the following message:
F11 = Boot Manager
If your operating system begins to load before you press F11, allow the system to complete the booting, and then restart your system
and try again.
Identifier
Status

Boot Manager main menu

Menu item Description
Continue Normal The system attempts to boot to devices starting with the first item in the boot order. If the boot attempt fails, the
Boot system continues with the next item in the boot order until the boot is successful or no more boot options are
found.
One-shot Boot Enables you to access boot menu, where you can select a one-time boot device to boot from.
Menu
Launch System Enables you to access System Setup.
Setup
Launch Lifecycle Exits the Boot Manager and invokes the Dell Lifecycle Controller program.
Controller
System Utilities Enables you to launch System Utilities menu such as System Diagnostics and UEFI shell.
GUID-DFDB3F1A-6F51-4D6D-9E60-F97D7A22C981
Released
GUID-8BA1974A-0675-4C75-90CF-5DF4F0310B23
Released
GUID-3468D45C-160D-426D-85C8-A27F0DB6348C
Released
NOTE: The Dell EMC Storage NX3240 system does not support UEFI mode.
Pre-operating system management applications 61