Viewing System Setup; System Setup Details - Dell EMC NX3240 Installation And Service Manual

• Text browser—The browser is enabled by using Console Redirection.
Identifier
Status

Viewing System Setup

To view the System Setup screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart
your system and try again.
Identifier
Status

System Setup details

The System Setup Main Menu screen details are explained as follows:
NOTE: The Dell EMC Storage NX3240 system does not support UEFI mode.
Option Description
System BIOS Enables you to configure BIOS settings.
iDRAC Settings Enables you to configure the iDRAC settings.
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI (Unified
Extensible Firmware Interface). You can enable or disable various iDRAC parameters by using the iDRAC settings
utility. For more information about this utility, see Integrated Dell Remote Access Controller User's Guide at
Dell.com/idracmanuals.
Device Settings Enables you to configure device settings.
GUID-311682C4-80BA-419A-B2D7-261BFF0464F3
Released
GUID-579645A3-EE1B-42D5-AB1D-5D83788282A4
Released
Pre-operating system management applications 39