Table of Contents
Advertisement
Figure 15. Installing the front bezel with the LCD panel
NOTE:
The images shown here are for representation only and the actual configuration of your system may vary.
Identifier
Status
System cover
System cover provides security for the entire system and also helps in maintaining proper air flow inside the system.
This section contains information about the removal and installation of the system cover.
Identifier
Status
Removing the system cover
Prerequisites
1
Follow the safety guidelines listed in
2
Turn off the system, including any attached peripherals.
3
Disconnect the system from the electrical outlet and disconnect the peripherals.
Steps
1
Using a 1/4 inch flat head or a Phillips #2 screwdriver, rotate the latch release lock counter clockwise to the unlocked position.
2
Lift the latch till the system cover slides back and the tabs on the system cover disengage from the guide slots on the system.
3
Hold the cover on both sides, and lift the cover away from the system.
66
Installing and removing system components
GUID-52869831-5B98-41AE-B6A3-C7045DB915D6
Released
GUID-5F7CAC65-CA63-4069-BF36-AFA4DCC05ABD
Released
Safety
instructions.
Hide quick links:
Advertisement
Table of Contents
