Figure 95. Cable routing – 4 x 3.5 mid backplane with 12 x 3.5-inch backplane
1
backplane
3
mid backplane
5
mid backplane power cable (Mid BP: J_BP_PWR to MB)
Identifier
Status
System battery
The system battery is used for low-level system functions such as powering the real-time and date settings of the system.
This section contains information about replacing the system battery.
Identifier
Status
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
GUID-E6FDE17E-040B-44A4-BBEE-0C1D53AEF88B
Released
GUID-3CD7DC6E-73CA-4B56-AAC9-49B7DDD6102E
Released
Safety
instructions.
Before working inside your
2
SAS cable (BP: BP: A1 BP SAS to mid BP: J_SAS_A1,
J_SAS_B1)
4
mid backplane signal cable (Mid BP: J_BP_SIG to MB)
system.
Installing and removing system components
143