Table of Contents
Advertisement
Figure 46. Installing a drive into the drive carrier
Identifier
Status
Rear drive cage
The drive cage supports two 3.5-inch drives or two 2.5-inch drives in 3.5-inch hybrid carriers.
This section contains information about the removal and installation of the rear drive cage.
Identifier
Status
Removing a rear drive cage
The procedure for removing 2.5-inch and 3.5-inch rear drive cages is identical.
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove all the drives.
4
Disconnect all the cables from the rear drive backplane.
5
Remove the rear drive backplane.
Steps
1
Using Phillips #2 screwdriver, loosen the screws that secure the drive cage to the system.
2
Hold the drive cage by its sides, and lift it away from the system.
98
Installing and removing system components
GUID-B470A10B-5080-4C2E-8B99-C518139C63A4
Released
GUID-3E64C7C0-6962-4731-9EE2-730BD21C9EC3
Released
Safety
instructions.
Before working inside your
system.
Hide quick links:
Advertisement
Table of Contents
