Turntable Covers - Genie S-80 Service Manual

Section 7 - Repair Procedures

Turntable Covers

5-1
Turntable Covers
How to Remove a
Turntable Cover
1 Raise the turntable cover. Support the open
cover with an overhead crane or forklift.
Do not lift it.
Crushing hazard. Due to its heavy
weight, do not attempt to support
the cover by hand.
2 Remove the upper and lower retaining clips
from the gas strut.
3 Gently pry the strut pivot sockets off of the ball
studs and remove the strut. Protect the strut
cylinder rod from damage.
4 Remove the cover hinge bolts, that fasten the
hinge support bracket to the bulkhead.
5 Carefully lift and remove the cover from
the machine.
If a turntable cover must be
replaced, be sure that all
appropriate safety and
instructional decals are
applied to the new cover.
Alignment adjustments may be
necessary when a new cover
is installed.
7 - 22 Genie S-80 & Genie S-85
Service Manual - First Edition
Part No. 34032