Foot Switch - Genie S-80 Service Manual

Section 7 - Repair Procedures
PLATFORM CONTROLS
12 Disconnect the volt meter.
13 Raise the boom above the drive limit switch.
a
a drive limit switch
b boom extension cylinder
14 Drive the machine for 40 feet (12 m) and
record the elapsed time. Repeat this step in
the opposite drive direction.
15 Adjust the "B" potentiometer to obtain the
correct raised drive speed of 1 foot per second
(30.5 cm per second). Turn the "B"
potentiometer counterclockwise to increase
voltage or clockwise to decrease voltage.
16 Close the platform control box lid and install
the fasteners.
Drive speed specifications
Stowed position
Gasoline/LPG models
Deutz Diesel models
Boom raised or
extended
All models
7 - 8
b
distance: 40 ft / 12 m
2WD
40 ft/7.2 sec 40 ft/8.8 sec
12.2 m/7.2 sec 12.2 m/8.8 sec
40 ft/8.3 sec 40 ft/9.1 sec
12.2 m/8.3 sec 12.2 m/9.1 sec
distance: 40 ft / 12 m
1 foot per second
30.5 cm per second
Genie S-80 & Genie S-85
1-3

Foot Switch

How to Test the Foot Switch
1 Turn the key switch to the
separate the wiring quick disconnect plug from
the platform toe board.
2 Do not press down the foot switch. Connect the
leads from an ohmmeter or continuity tester to
each wire combination listed below and check
for continuity.
Test
green to black
green to white
black to white
3 Press down the foot switch. Connect the leads
from an ohmmeter or continuity tester to each
wire combination listed below and check for
continuity.
Test
green to black
4WD
green to white
black to white
Service Manual - First Edition
position and
OFF
Desired result
Do not use the color of the
connector as a guide for these
tests. Use the actual wire color
to identify which connector to
use for testing.
Desired result
Part No. 34032
continuity
(zero W)
no continuity
(infinite W)
no continuity
no continuity
(infinite W)
no continuity
continuity
(zero W)