Wago ® Components; Resistor - Genie S-80 Service Manual

Service Manual - First Edition
8-2
Toggle Switches
See 1-5, Toggle Switches.
8-3
®
Wago Components
How to Remove a Wago
Component
Electrocution hazard.
Contact with electrically charged
circuits may cause death or
serious injury. Remove all rings,
watches and other jewelry.
A small screwdriver is provided
and should be used when
removing a Wago
This screwdriver is located in the
operator's manual storage box in
the platform.
1 Label the wiring from the component to be
removed.
2 Use the provided screwdriver to push in and
release the wire from the component.
3 Locate the removal tab on the bottom or top
side of the component.
4 Use the provided screwdriver to gently pry up
on the tab of the component and remove it.
Part No. 34032
8-4
Resistors
How to Test the Resistor
The resistor is used to maintain proper control of
boom function speeds. A 10 ohm resistor reduces
voltage to all the boom function switches.
®
1 Turn the key switch to the
2 Disconnect either end of one of the wires
3 Connect the leads from an ohmmeter to each
4 Compare the ohmmeter reading with the
® component.
Genie S-80 & Genie S-85
Section 7 - Repair Procedures
Refer to the schematic legends for
resistor locations and values.
connected to the resistor to be tested.
end or wiring of the resistor being tested.
resistance rating printed on the resistor.
GROUND CONTROLS
position.
OFF
7 - 29