Genie S-80 Service Manual page 58

Section 4 - Scheduled Maintenance Procedures
TABLE C PROCEDURES
3 Drive the machine until one plug is at the top
and the other is at 90 degrees.
4 Fill the hub with oil from the top hole until the oil
level is even with the bottom of the side hole.
Apply pipe thread sealant to the plugs, and
then install the plugs.
5 Repeat steps 1 through 4 for all the other drive
torque hubs.
Non-steer end:
6 Remove the torque hub. See 17-2, How to
Remove a Drive Torque Hub. After removing
the torque hub, drain and replace the oil from
the inside torque hub.
Oil capacity per hub
non-steer (outside)
non-steer (inside)
steer
Type: SAE 90 multipurpose hypoid gear oil - API
service classification GL5
4 - 30
50 fl oz 1.47 liters
4 fl oz 0.11 liters
44 fl oz 1.30 liters
Genie S-80 & Genie S-85
Service Manual - First Edition
Turntable Rotate Torque Hub
1 Secure the turntable from rotating with the
turntable rotation lock pin.
unlocked
2 Remove the motor/brake mounting bolts, and
then remove the motor and brake from the
torque hub and set them to the side.
a
f
e
a motor/brake mounting bolt
b motor
c torque hub
d torque hub mounting bolt
e plug
f brake
3 Remove the torque hub mounting bolts, and
then use a lifting device to remove the torque
hub from the machine.
4 Remove the plug from the side of the torque
hub. Then drain the oil from the hub.
locked
b
c
d
Part No. 34032