Resistors; Toggle Switches - Genie S-80 Service Manual

Service Manual - First Edition
1-4

Resistors

The resistors is used on 4WD machines to
maintian low range drive speed. The resistors are
located in the platform control box.
Refer to the schematic legends
for resistor locations and values.
How to Test the Resistors
1 Turn the key switch to the
2 Disconnect either end of one of the wires
connected to the resistor to be tested.
3 Connect the leads from an ohmmeter to each
end or wiring of the resistor being tested.
4 Compare the ohmmeter reading with the
resistance rating printed on the resistor.
1-5

Toggle Switches

Toggle switches used for single function switching
are single pole double throw (SPDT) switches.
Dual function switching requires a double pole
double throw (DPDT) switch.
How to Test a Toggle Switch
Continuity is the equivalent of 0 to
3 ohms. A simple continuity tester
may not accurately test the switch.
This procedure covers fundamental switch testing
and does not specifically apply to all varieties of
toggle switches.
1 Turn the key switch to the
and disconnect all wiring from the toggle switch
to be tested.
2 Connect the leads of an ohmmeter to the
switch terminals in the following combinations
listed below to check for continuity.
Part No. 34032
position.
OFF
position. Tag
OFF
Genie S-80 & Genie S-85
Section 7 - Repair Procedures
Left
1 3
2
Single pole
double throw
(SPDT)
1 2 3
4 5 6
Double pole
double throw
(DPDT)
1 2 3
Test
Left position
terminal 1 to 2, 3, 4, 5 & 6
terminal 2 to 3
terminal 2 to 4, 5 & 6
terminal 3 to 4, 5 & 6
terminal 4 to 5 & 6
terminal 5 to 6
Center position There are no terminal combinations
Right position
terminal 1 to 2
terminal 1 to 3, 4, 5 & 6
terminal 2 to 3, 4, 5 & 6
terminal 3 to 4, 5 & 6
terminal 4 to 5
terminal 4 to 6
terminal 5 to 6
PLATFORM CONTROLS
Center Right
1 3 1
2 2
1 2 3 1 2
4 5 6 4 5
1 2 3 1 2
Desired result
no continuity
(infinite W)
continuity
(zero W)
no continuity
no continuity
no continuity
continuity
that will produce continuity
(infinite W)
continuity
(zero W)
no continuity
(infinite W)
no continuity
no continuity
continuity
no continuity
no continuity
7 - 9
3
3
6
3