Genie S-80 Service Manual page 61

Service Manual - First Edition
1 Remove the 2 bolts from under the engine pivot
plate. Swing the engine pivot plate away from
the machine to access the fuel filter, located
near the carburetor.
a
a pivot plate retaining bolts
b engine pivot plate
2 Loosen the filter bracket mounting bolt.
Disconnect the fuel hoses from the filter, then
slide the filter out of the bracket.
Part No. 34032
b a
Genie S-80 & Genie S-85
Section 4 - Scheduled Maintenance Procedures
TABLE C PROCEDURES
d
Gasoline/LPG models
a fuel filter
b hose from the fuel filter to
the carburetor
c hose from the fuel pump to
the fuel filter
d hose from the fuel shutoff
valve to the fuel pump
3 Install the new fuel filter in the bracket with
the flow direction arrow on the filter, pointing
toward the carburetor. Tighten the bracket
mounting bolt, then connect the fuel hoses
to the filter.
4 Clean up any fuel that may have spilled during
the installation procedure.
5 Start the machine from the ground controls,
then inspect the fuel filter and hoses for leaks.
If a fuel leak is discovered, keep
any additional personnel from
entering the area and do not
operate the machine. Repair
the leak immediately.
6 Swing the engine pivot plate back to its original
position and replace the two retaining bolts.
a b
4 - 33
c