Wiring The Power Supply - Emerson Micro Motion 5700 Installation Manual

December 2014
4

Wiring the power supply

A user supplied switch may be installed in the power supply line.
Important
For compliance with the Low Voltage Directive 2014/35/EU (European installations), a switch in
close proximity to the transmitter is required.
Procedure
1. Remove the wiring access cover.
2. Open the Power warning flap to locate the power terminals.
Figure 4-1:
A. Power supply wiring terminals (+ and -)
B. Equipment ground
3. Connect the power supply wires:
• For DC power: connect to terminals + and –.
• For AC power: connect to terminals L/L1 (line) and N/L2 (neutral).
4. Tighten the 2 screws holding the power connector in place.
Quick Installation Guide
Location of power supply wiring terminals and
equipment ground
Installation Manual
45