Emerson Micro Motion 5700 Installation Manual page 21

December 2014
2. Loosen and rotate the end cap clamp so that it does not interfere with the
cover.
3. Turn the display cover counterclockwise to remove it from the main
enclosure.
4. Carefully loosen the semi-captive display screws while holding the display
module in place.
5. Carefully pull the display module out of the main enclosure.
6. Rotate the display module to the desired position.
7. Gently press the display module back onto the connector.
8. Tighten display screws.
9. Place the display cover onto the main enclosure.
10. Turn the display cover clockwise until it is fully seated.
11. Replace the end-cap clamp by tightening the cap screw.
12. Restore power to the transmitter.
2.7 Rotate the sensor wiring junction box on a remote-mount
transmitter (optional)
In remote-mount installations, you can rotate the sensor wiring junction box
on the transmitter plus or minus 180º.
1. Using a 4 mm hex key, loosen and remove the clamp securing the sensor
wiring junction box in place.
Quick Installation Guide
Installation Manual
21