If The Operating System Does Not Boot From The Floppy Disk Drive - Agilent Technologies E8362B Service Manual

Operating System Recovery
System Recovery Procedure

If the Operating System Does Not Boot From the Floppy Disk Drive

You may have to change the network analyzer Bios settings to have it scan the floppy disk
drive before booting from the hard disk drive. Due to Bios revisions, the exact procedure
may vary slightly from the following:
1. Attach a keyboard to the network analyzer and restart the network analyzer.
2. When the Agilent logo appears, press function key
The menu will appear after several seconds.
Bios
3. Using the keyboard arrows, select Boot. Use the keyboard to edit the file to select
booting from the floppy disk drive before attempting to boot from the hard disk drive.
Once the restoration process is complete and the analyzer is functioning
NOTE
properly, remove the floppy disk and use this same procedure to change back
to booting from the hard disk drive. If you do not do this, an error will result
each time the analyzer is powered up with a floppy disk installed.
4. Select , and then
Save
5. Now that the Bios has been changed to allow the system to detect the DOS boot disk in
the floppy disk drive, continue with the procedure at step 5 of
Does Not Boot From the Hard Disk Drive" on page
D-6
.
Exit
PNA Series Microwave Network Analyzers
E8362B, E8363B, E8364B
, on the keyboard, several times.
F2
"If the Operating System
D-5.
Service Guide E8364-90026