HPE ProLiant XL170r Gen10 User Manual page 39

CAUTION: Be sure to tighten each heatsink nut fully in the order indicated. Otherwise, boot
failure or intermittent shutdowns might occur.
c. Using a T-30 Torx screwdriver, fully tighten each heatsink screw in the order indicated on the
heatsink label (1 -2 -3 -4) until it no longer turns.
11. Remove the expansion slot blank.
12. Connect the cables to the fabric processor enablement board.
13. Install the fabric processor enablement board into slot 1. Ensure that the component is firmly seated
in the connector.
Hardware options installation 39