HPE ProLiant XL170r Gen10 User Manual page 37

CAUTION: To avoid damage to the processor or system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: Heatsink processor assemblies specified for processor 1 and 2 are not
interchangeable. Be sure to note the appropriate orientation on the heatsink label.
CAUTION: To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
CAUTION: If installing a processor with a faster speed, update the system ROM before
installing the processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise
Support Center website.
CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid
damage to the socket or processor, do not touch the contacts.
2. Back up all server data.
3. Power down the server.
4. Remove the server from the chassis.
5. Remove the air baffle.
6. If a secondary PCI riser cage is installed, remove the bayonet board.
7. Do one of the following:
• Remove the secondary PCI riser blank.
• Remove the secondary PCI riser cage.
8. Do one of the following:
• Remove the primary PCI riser blank.
• Remove the primary PCI riser cage.
9. Remove the existing processor 1 heatsink assembly:
a. Allow the heatsink to cool.
b. Loosen the heatsink nuts in the order specified by the label on the heatsink (4 - 3 - 2 - 1).
Hardware options installation 37