Chapter 1 About This Manual; Purpose Of This Manual; References - ADLINK Technology CoreModule 740 Reference Manual

Chapter 1

Purpose of this Manual

This manual is for designers of systems based on the CoreModule™ 740 single board computer (SBC). This
manual contains information that permits designers to create an embedded system based on specific design
requirements.
Information provided in this reference manual includes:
•
Product Overview
•
Hardware Specifications
•
BIOS Setup information
•
Technical Support Contact Information
Information not provided in this reference manual includes:
•
Detailed chip specifications
•
Internal component operation
•
Internal registers or signal operations
•
Bus or signal timing for industry standard busses and signals
•
Pinout definitions for industry standard interfaces

References

The following list of references may help you successfully complete your custom design.
Specifications
•
PC/104 Specification, Revision 2.5, November, 2003
•
PC/104-Plus Specification, Revision 2.0, November, 2003
For latest revision of the PC/104 specifications, contact the PC/104 Consortium, at:
Web site: http://www.pc104.org
•
PCI 2.2 Compliant Specifications, Revision 2.2, December 18, 1998
For latest revision of the PCI specifications, contact the PCI Special Interest Group at:
Web site: http://www.pcisig.com
Chip Specifications
The following integrated circuits (ICs) are used in the CoreModule 740 single board computer:
•
Intel® Corporation and the N450 processor
Web site:
http://www.intel.com/products/processor/atom/techdocs.htm
•
Intel and the ICH8-M chip, used for the I/O Hub (Southbridge)
Data sheet:
http://www.intel.com/assets/pdf/datasheet/313056.pdf
•
SMSC and the Super I/O SCH3112I-NU chip used for the Super I/O controller
Data sheet:
http://www.smsc.com/media/Downloads_Public/Data_Briefs/311xdb.pdf
CoreModule 740
About This Manual
Reference Manual 1