Configuring The Battery Bank Type - Xantrex Truecharge2 Series Installation Manual

Configuring the Battery Bank Type

Using the Onboard Display Panel
Using the Remote Panel
975-0402-01-01
Downloaded from Elcodis.com electronic components distributor
Configuring the Truecharge™ 2 Battery Charger
To configure the battery bank type:
Note: By default, the battery type is set to Flooded.
1. Press and hold the Battery Type Select button for three
seconds to advance to the next setting.
2. Select the proper battery type.
The LEDs will indicate which of the four types is being
selected: Flooded (default), GEL, Lead Calc., AGM.
However, if a custom battery type has been programmed
by the OEM, all four LEDs will light up to indicate a fifth
type.
To configure the battery bank type:
Note: By default, the battery type is set to Flooded.
1. Press and hold the Status button for five seconds to enter
the Setup mode.
Entering the Setup mode will enable you to select the
battery type.
2. Press Set Max Output button to select the proper battery
type.
The LEDs will indicate which of the four types is being
selected: Flooded (default), GEL, Lead Calc., or AGM.
However, if a custom battery type has been programmed
by the OEM, all four LEDs will light up to indicate a fifth
type.
3. Press and hold the Status button for five seconds to exit
the Setup mode.
This guide for use by qualified installers only
2–29