Veeco MS40 Operation And Maintenance Manual page 97

Installation:
Vacuum Instrument Corp.
2099 Ninth Avenue
Ronkonkoma, NY 11779
631.737.0900
1109-186-00 Rev. C
10. Carefully bend both filament contacts slightly more then 90° away
from the filament side of the assembly.
11. Place the filament on the source assembly. Guide the contacts with
the slots provided on the ceramic block.
12. Place the ceramic spacer on the source assembly. Reattach the
spacer with the nuts removed in Step 8.
13. Slide the filament up or down in the slots of the ceramic block until
the top edge of the filament is aligned with the center slit of the
source assembly (refer to Figure 4-4).
4-28