1.2 Unpacking & Inspection - Veeco MS40 Operation And Maintenance Manual

Chapter 4, Service & Maintenance, describes in further detail the unit's
Service Mode, the necessary tuning/calibration procedures for the MS-40,
required periodic service procedures and recommended service intervals,
detection and correction of contamination within the vacuum system,
procedures for venting the vacuum system, cleaning requirements and
procedures, calibration of measurement components, valve block service and
repair, repair/replacement of the unit's electronics and a full listing of front
panel error codes, their probable causes and our recommended corrective
actions.
Chapter 5, MS-40 Parts Lists, contains a full list of recommended spare parts
and a complete listing of the spare parts available from VIC.
This manual provides the specific documentation needed to operate and
service the MS-40 Leak Detector. The MS-40 System is a highly technical
system that incorporates many sophisticated technologies. In view of this,
every effort has been made to automate both the unit's operation and
maintenance procedures. It is imperative, however, that operations and service
personnel familiarize themselves with the operations and maintenance
procedures in this manual in order to maximize the efficiency of the unit, as
well as minimize downtime caused by improper service and repair.
1.2 Unpacking & Inspection
The MS-40 is shipped in a specially constructed package that minimizes the
possibility of damage during transit. The shipping carton and packing
materials should be saved for future use. Note that a Bill of Material is packed
within the carton indicating all of the items shipped with the unit.
Prior to unpacking the unit, inspect the exterior carton for any signs of
damage. After unpacking the unit, inspect the leak detector itself for any
obvious damage. If damage to the unit is found, a claim should be filed
immediately with the shipping carrier and a copy of that claim must also be
forwarded to Vacuum Instrument. Should the MS-40 fail to function as
required, or fail to meet its specifications, contact the Customer Service
Department at VIC (Vacuum Instrument, 2099 Ninth Avenue Ronkonkoma,
NY 11779, 631-737-0900) or your local representative. Please note that
Vacuum Instrument must be contacted prior to the return of any damaged
equipment.
Once the leak detector has been removed from its package, the MS-40 must
be opened and all shipping material removed from the unit's internal
Vacuum Instrument Corp.
roughing and turbo-molecular pumps. To access the internal roughing
2099 Ninth Avenue
Ronkonkoma, NY 11779
pump, the front panel must be opened to access the turbo-molecular pump,
631.737.0900
1109-186-00 Rev. C 1-3