Framing; Appliance Placement Considerations; Stand-Off Assembly And Installation - kozy heat CALLAWAY 50 Installation And Operation Manual

3.0 FRAMING

3.1 Appliance Placement Considerations

WARNING: Due to high temperatures, the appliance should be located
out of traffic and away from furniture and draperies.
• This appliance must be installed on a level surface capable
of supporting the fireplace and venting. If possible, place the
fireplace in a position where the vent terminates between two
studs, eliminating the need for any additional framing.
• This fireplace may be installed in a bedroom.
• Please be aware of the large amount of heat this fireplace will
produce when determining a location.

3.2 Stand-off Assembly and Installation

NOTE: If installing the Komfort Zone Kit, please reference the manual
included with kit.
WARNING: The top stand-offs brackets provide the required minimum
clearance to the header. The clearance to header must be maintained.
Figure 3.1, Stand-off Assembly and Installation
#CLW-50 R.1 March 2018
Top stand-off brackets must be formed and attached prior to
positioning fireplace into framed opening.
1. Remove and save (4) screws securing the stand-off brackets on
top of the fireplace.
2. Form each stand-off bracket by bending at perforations, as
shown.
3. Align the holes in the formed stand-off brackets with the
holes on top of the fireplace. Secure with (4) screws previously
removed along with (4) screws provided in the fireplace
components packet.
4. Remove and save screws securing the back stand-off brackets.
Form the back stand-off heat shields as shown. Secure using
provided screws.
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces FRAMING 11