3. LED
DMX
MASTER
SLAVE
SOUND
4. Power In: Connect to supply mains power;
5. Power Out: Connect to supply mains power for the next unit;
6. Fuse(T6.3Amp): Used to protect the unit from the damage of over current;
7. 3‐pin DMX In: For DMX512 link, use 3‐pin XLR cable to link the unit and the DMX controller;
8. 3‐pin DMX Out: For DMX512 link, use 3‐pin XLR cable to link the next unit and output DMX
signal;
9. 5‐pin DMX In: For DMX 512 link, use 5‐pin XLR cable to link the unit and the DMX controller;
10. 5‐pin DMX Out: For DMX 512 link, use 5‐pin XLR cable to link the next unit and output DMX
signal;
11. NUTR RJ45 in/out: Connect with the multimedia and use software to control the units via
ArtNet.
5.2 Main Function
To select any of the given functions, press the MENU button up to when the required one is
showing on the display. Select the function by the ENTER button and the display will blink. Use the
DOWN and UP button to change the mode. Once the required mode has been selected, press the
ENTER button to setup, to go back to the functions without any change press the MENU button
again. Hold and press the MENU button about one second or wait for one minute to exit the menu
mode.
Note: Under the master mode, hold the ENTER button and use the DOWN and UP button to
adjust the dimmer for the show.
On
On
On
Flash
DMX input present
Master Mode
Slave Mode
Sound activation
9A