Mater/Slave Built In Preprogrammed Function; Dmx Controller; Artnet; Dmx Configuration - ACME LED-MTX36 HEX User Manual

6.1 Mater/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give an
automatic light show. You have to set the first unit in master mode and select Show 1 to Show 10.
Its DMX input jack will have nothing plugged into it, and Its master LED will be constantly on and
sound LED will flash to the music.
6.2 DMX Controller
By using a universal DMX controller to control the units, you have to set DMX address from 1 to
512 so that the units can receive DMX signal.
Press the MENU button up to when the DMX Address is showing on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to change the DMX512 address. Once
the address has been selected, press and keep ENTER button pressed up to when the display stops
blinking or storing automatically 8 seconds later. To go back to the functions without any change
press the MENU button again. If you use please refer to the following diagram to address your
DMX512 channel for the first 4 units：
Channel mode
3 Channel
4 Channels
36RGB (108) Channels
36RGBW (144) Channels
36RGBWPY (216) Channels
6.3 ArtNet
By using multimedia software via ArtNet to control the units, you have to select channel mode 36
in the menu. Also set the Eth‐Net address to make sure they are same with the multimedia service.
If MAC address has conflict please use the random address.
6.4 DMX Configuration
3 Channels Mode:
Unit 1 Unit 2
Address Address
1 4
1 5
1 109
1 145
1 217
14A
Unit 3 Unit 4
Address Address
7 10
9 13
217 325
289 433
433 /