Safety Instructions - ACME LED-MTX36 HEX User Manual

1. Safety Instructions
WARNING
 Please keep this User Manual for future consultation. If you sell the fixture to another user, be
sure that they also receive this instruction booklet.
 Please unpack and check carefully there is no transportation damage before using the fixture.
 Please disconnect main power before servicing and maintenance.
 The maximum ambient temperature is Ta: 40 . D
higher than this.
 DO NOT connect the device to any dimmer pack.
 The housing must be replaced if they are visibly damaged.
 Unit surface temperature may reach up to 85 . Don't
operation. Turn off the power and allow about 15 minutes for the unit to cool down before
replacing or serving.
 There are no user serviceable parts inside the fixture. Do not open the housing or attempt any
repairs by yourself. In the unlikely event your fixture may require service, please contact your
nearest dealer.
 In the event of serious operating problem, stop using the fixture immediately. Never try to repair
the fixture by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center. Always use the
same type spare parts.
Warning:
 It's important to ground the yellow/green conductor to earth in order to avoid
electric shock.
 DO NOT touch any wire during operation and there might be a hazard of electric shock.
 To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
Please read carefully the instruction, which includes important
information about the installation, usage and maintenance.
℃
O NOT operate it where the temperature is
℃
touch the housing bare‐hand during its
2A