Table of Contents
Advertisement
English
DANGER -To reduce the risk of electrocution:
1.
Always unplug this product immediately after using.
2.
Do not use while bathing.
3.
Do not place or store product where it can fall or be pulled into a tub or sink.
4.
Do not place in or drop into water or other liquid.
5.
Do not reach for a product that has fallen into water. Unplug immediately.
6.
If product falls into water or other liquids do not reach into the water or other liquids. Unplug
immediately.
WARNING -To reduce the risk of burns, electrocution, fire or injury to persons:
1.
This product should never be left unattended when plugged in.
2.
Close supervision is necessary when this product is used with or near children or invalids. Choking
resulting from a child swallowing a small part that has become detached from the device or its
accessories.
3.
Use this product only for its intended use as described in this manual, do not use attachments not
recommended by the manufacturer.
4.
Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water. Return the product to a service centre for
examination and repair.
5.
Keep the cord away from heated surfaces.
6.
Never block the air openings of this product or place it on a soft surface, such as a bed or couch,
where the air openings may be blocked. Keep the air opening free of lint, hair, and other similar
particles.
7.
Never drop or insert any object into any opening or hose.
8.
Follow the national requirementfor disposing of the unit.
9.
Do not operate the device before the mask and water chamber have been installed.
10. Disconnect the water chamber from the device when not in use, water entering the device may
result in electric shock hazard or damage.
11. Do not use if water comes in contact with the device or enters the tubing.
12. This device is not for use with patients whose supraglottic airways have been bypassed.
13. Do not cover the device with blankets or clothes .
14. Do not remove water chamber while humidifier is heating. Do not touch the heater plate for 30
minutes after the device is disconnected from the mains.
15. No modification of this equipment is allowed.
16. Do not modify this equipment without authorization of the manufacturer.
17. If this equipment is modified, appropriate inspection and testing must be conducted to ensure
continued safe use of the equipment.
18. Do not leave long lengths of air tubing around the top of your bed. It could twist around your head
or neck while you are sleeping and lead to strangulation.
2
Italiano
3 A/m
Campo magnetico della
frequenza di alimentazione
(50/60Hz)
IEC61000-4-8
NOTE: U
rappresenta la tensione dell'alimentazione c.a. prima dell'applicazione del livello di prova.
T
Guida e dichiarazione del produttore - Immunità elettromagnetica
Questo dispositivo è stato progettato per l'uso nell'ambiente elettromagnetico specificato di seguito.
L'utente di questo dispositivo si deve assicurare che venga utilizzato in un ambiente di questo tipo.
Test di immunità
Livello del test
IEC60601
RF condotta IEC 61000-4-6
3 Vrms da 150
kHz a
80 MHz fuori dalle
a
bande ICM
RF irradiata IEC 61000-4-3
3 V/m
Da 80 MHz a
2,5 GHz
3 A/m
I campi magnetici della
frequenza di alimentazione
devono essere pari ai livelli
caratteristici di una sede tipica
in un ambiente commerciale o
ospedaliero comune.
Conformità
Ambiente elettromagnetico –
Guida
I dispositivi di comunicazione a
radio frequenza portatili e
mobili devono essere utilizzati
lontano da qualsiasi parte di
questo dispositivo (compresi i
cavi), alla distanza di
separazione minima
consigliata, calcolata con
l'equazione applicabile alla
frequenza del trasmettitore.
Distanza di separazione
consigliata:
d = 1,2√P da 150kHz a 80MHz
3 Vrms
d = 1,2√P da 150kHz a 80MHz
d = 2,3√P da 80MHz a 2,5G
MHz
3 V/m
Dove P rappresenta l'indice di
potenza di trasmissione
massimo del trasmettitore in
Watt (W), secondo il produttore
del trasmettitore, e d
rappresenta la distanza di
separazione consigliata in metri
b
(m)
.
Le intensità di campo dei
trasmettitori RF fissi, in base a
una ricerca
c
sull'elettromagnetismo
devono essere inferiori al livello
171
,
Advertisement
Table of Contents
