Important Safety Information; Read This First; Product Labels; Safety And Advisory Symbols - enphase M215-60-2LL-S23-IG Installation And Operation Manual

Important Safety Information

Read this First

This manual contains important instructions for use during installation and maintenance of the Enphase M215
Microinverter™.

Product Labels

The following symbols appear on the product label and are described here:
WARNING: Hot surface.
DANGER: Risk of electrical shock.
Refer to product instructions.

Safety and Advisory Symbols

To reduce the risk of electrical shock, and to ensure the safe installation and operation of the Enphase®
Microinverter, the following safety symbols appear throughout this document to indicate dangerous conditions and
important safety instructions.
DANGER! This indicates a hazardous situation, which if not avoided, will result in death or serious
injury.
WARNING! This indicates a situation where failure to follow instructions may be a safety hazard or
cause equipment malfunction. Use extreme caution and follow instructions carefully.
WARNING! This indicates a situation where failure to follow instructions may result in burn injury.
NOTE: This indicates information particularly important for optimal system operation. Follow
instructions closely.

Safety Instructions

DANGER: Before installing or using the Enphase Microinverter, read all instructions and cautionary
markings in the technical description, on the Enphase Microinverter System, and on the
photovoltaic (PV) equipment.
DANGER: Do not use Enphase equipment in a manner not specified by the manufacturer. Doing
so may cause death or injury to persons, or damage to equipment.
DANGER: Risk of Electrical Shock. Be aware that installation of this equipment includes risk of
electric shock. Do not install the AC junction box without first removing AC power from the Enphase
System.
DANGER: The Engage Cable terminator cap must not be installed while power is connected.
DANGER: Electric shock hazard. The DC conductors of this photovoltaic system are ungrounded
and may be energized.
WARNING: Always de-energize the AC branch circuit before servicing. Never disconnect the DC
connectors under load. Disconnect DC connections first, and then disconnect AC connections.
5
 2014 Enphase Energy Inc. All rights reserved.
M215 Installation and Operation
141-00012 Rev 06