Step 1: Register The System - enphase M215-60-2LL-S23-IG Installation And Operation Manual

Step 1: Register the System

Register the Envoy at the beginning of
the PV installation.
a. Use your previously issued
username and password to log in
to in Enlighten.
If you haven't registered, go to
www.enphase.com
Enlighten Login.
b. At the installer dashboard, click
Add a New System.
If you have already registered the
site, find the system under
Installations in Progress.
c. Under System, enter the system
Name, Type and Installer
Reference (optional).
d. Enter Installer information.
e. Under Owner, enter the Name,
Email, and Phone.
f. Under Location, enter the Country
and address information.
g. Under Envoy, select the Internet
Connection type and enter the
Envoy Serial Number.
NOTE: If you have selected a
country other than the US, or if
you select Hawaii as the state
under Location, the Grid
Profile menu appears.
h. If required, select the appropriate
profile from the Grid Profile menu.
Skip this step in the continental US
because the factory settings meet
requirements.
i. Under Modules, enter total
number of modules, type, etc.
j. Click Save to submit the form. You
will receive a confirmation
message: "Activation Created
Successfully."
For more information on Grid Profiles
or if you need to change the grid
profile subsequent to this initial
procedure, see the Envoy
Communications Gateway
Installation and Operation Manual
at: http://www.enphase.com/support.
14
and click
 2014 Enphase Energy Inc. All rights reserved.
M215 Installation and Operation
141-00012 Rev 06