®
Advanced Energy
Table 5‑1. Module documentation links (Continued)
Anybus Module
Anybus Modbus RTU
If an Anybus module must be removed from the unit, loosen the TORX T8 mounting
screws 3 turns, and pry out the module with a small flat-bladed screwdriver, as
shown in the following figure.
Figure 5‑22. Anybus module removal
If an I/O module must be removed from the unit, remove the TORX T8 mounting
screws, insert a connector, and pull while moving the module from side to side, as
shown in the following figure.
57010148-00B
http://aei.com/en/
anybus_modbus_rtu.html
Installation, Setup, and Operation
Thyro-PX® Power Controller
Link
QR Code
5‑17