Mounting The Unit; Figure 5-2. Anybus Module Removal; Figure 5-3. I/O Module Removal - Advanced Energy Thyro-PX User Manual

®
Advanced Energy
Figure 5‑2. Anybus module removal
If an I/O module must be removed from the unit, remove the TORX T8 mounting
screws, insert a connector, and pull while moving the module from side to side, as
shown in the following figure.
Figure 5‑3. I/O module removal

Mounting the Unit

1. Install the unit on or in the mounting surface, rack, or cabinet.
2. Fasten the unit to the mounting surface, rack, or cabinet. Use suitable fasteners.
See "Dimensional Drawings"
57010241-00B
on page 5‑1 for mounting hole details.
Installation, Setup, and Operation
®
Thyro‑PX DC Power Controller
5‑5