Safety And Emc Directives And Standards; Conditions Of Use - Advanced Energy Thyro-PX User Manual

®
Advanced Energy

Safety and EMC Directives and Standards

For information concerning compliance to applicable EU requirements, refer to the
EU Declaration of Conformity for this unit. The Declaration of Conformity may also
include a supplementary section covering compliance to non-EU regulatory
requirements and/or industry standards or guidelines.

Conditions of Use

To comply with the stated directives and standards, you must meet the following
conditions of use:
• Before making any other connection to this product, connect the primary
Protective Earth (ground), and secondary Protective Earth (ground) if
applicable, to a local earth ground using wire that is sized according to the
applicable requirements.
• Install and operate this unit in an overvoltage category according to
environmental specifications.
• You must install and operate this device with a circuit breaker switch on the AC
input. The circuit breaker switch must be easily accessible and near the unit.
The breaker must be marked as the disconnecting device for the equipment.
• To provide the required overcurrent protection, install and operate this device
with an agency-rated circuit breaker of appropriate size on the AC input.
• Use only shielded cables on control interface cables.
• Use only shielded cables on serial and user communications interfaces.
• Limit the system load current to the maximum specified level for the unit.
• Dispose of this product as directed by applicable laws and regulations.
• For the input and output power connections, use wires that are suitable for at
least 75°C (167°F).
• Do not allow condensation of any liquids or accumulation of conductive dust on
the instrument. Doing so will have unpredictable results, possibly including, but
not limited to, loss of accuracy.
57010148-00B Safety and Product Compliance Guidelines
Thyro-PX® Power Controller
1‑5