Safety And Emc Directives And Standards; Conditions Of Use; Ul Markings And Requirements - Advanced Energy Thyro-PX Series User Manual

®
Advanced Energy
For more information, refer to the Certificate or Letter of Conformity (US) or
Declaration of Conformity (EU), available on request.
• CE Marking – Self-declaration, assessed by AE Corporate Compliance
• EMC measurements – Verified by AE Corporate Compliance
• UL registration file E135074 according to UL 508

Safety and EMC Directives and Standards

For information concerning compliance to applicable EU requirements, refer to the
EU Declaration of Conformity for this unit. The Declaration of Conformity might
also include a supplementary section covering compliance to non-EU regulatory
requirements and/or industry standards or guidelines.

Conditions of Use

To comply with the stated directives and standards, you must meet the following
conditions of use:
• Before making any other connection to this product, connect the primary
Protective Earth (ground), and secondary Protective Earth (ground) if
applicable, to a local earth ground using wire that is sized according to the
applicable requirements.
• Install and operate this unit in an overvoltage category according to
environmental specifications.
• You must install and operate this unit with a circuit breaker on the AC input.
The circuit breaker must be easily accessible and near the unit. The circuit
breaker must be marked as the disconnecting device for the equipment.
• Use only a shielded cable for communications and/or control connections.
• Limit the system load current to the maximum specified level for the unit.
• Dispose of this product as directed by applicable laws and regulations.
• For the input and output power connections, use wires that are suitable for at
least 75°C (167°F).
• Do not allow condensation of any liquids or accumulation of conductive dust on
the instrument. Doing so will have unpredictable results, possibly including, but
not limited to, loss of accuracy.

UL Markings and Requirements

To use the unit under UL conditions, you must comply with the following additional
conditions of use:
• Make electrical connections following the specified tightening torque. See
"Connecting Load and Auxiliary Power"
• Use 75°C copper conductors for power circuits.
57010148-00G Safety and Product Compliance Guidelines
®
Thyro-PX Power Controller
on page 5‑30.
1‑5