Table of Contents
Advertisement
1. Safety
Label image
本投影机安装透射比大于3.5的可换镜头后，可成为RG3，操作前， 请参考手册中镜头清单和
危险距离。本投影机与镜头组合仅供专业使用，非普通消费者使用。
For F80-Ultra, F80-4K9, F80-Q9 :
837
837
3
For North America: THIS PRODUCT IS IN CONFORMITY WITH PERFORMANCE
STANDARDS FOR LASER PRODUCTS UNDER 21 CFR 1040, EXCEPT WITH RESPECT
TO THOSE CHARACTERISTICS AUTHORIZED BY VARIANCE NUMBER 2017-V-4837
EFFECTIVE September 13, 2017.
This projector may become RG3 when an interchangeable lens with throw ratio greater than
2.8 is installed. Refer to the manual for the lens list and hazard distance before operation.
Such combinations of projector and lens are intended for professional use only, and are not
intended for consumer use.
Ce projecteur peut devenir un projecteur RG3 en cas d'installation d'un objectif
interchangeable dont le rapport de projection est supérieur à 2.8. Veuillez vous reporter
au manuel pour en savoir plus sur la liste des objectifs et la distance de sécurité avant
toute utilisation. De telles combinaisons entre projecteur et objectif sont conçues pour des
applications professionnelles uniquement et pas pour des applications grand public.
本投影机安装透射比大于2.8的可换镜头后，可成为RG3，操作前， 请参考手册中镜头清单和
危险距离。本投影机与镜头组合仅供专业使用，非普通消费者使用。
1.4
Risk Group 3 Safety
1.4.1
General considerations
Notice on optical radiation from F80 Projector when it becomes Risk Group 3.
•
For RG3, no direct exposure to the beam shall be permitted.
For RG3, operators shall control access to the beam within the hazard distance or install the product at a height that will prevent
eye exposure within the hazard distance.
•
This projector has one or several built-in Class 4 laser clusters. Disassembly or modification is very dangerous and should
never be attempted.
•
Any operation or adjustment not specifically instructed by the user's guide creates the risk of hazardous laser radiation expo-
sure.
•
Do not open or disassemble the projector as this may cause damage by the exposure of laser radiation.
FOR PROFESSIONAL USE ONLY means installation can only be carried out by Barco AUTHORIZED PERSONNEL familiar with
potential hazards associated with high intensity light beams.
W
ARNING
3) IEC 62471-5:2015
C
AUTION
may result in hazardous radiation exposure.
1.4.2
High Brightness precautions: Hazard Distance (HD)
HD
Hazard Distance (HD) is the distance measured from the projection lens at which the intensity or the energy per surface
unit becomes lower than the applicable exposure limit on the cornea or on the skin. The light beam is considered (to
be) unsafe for exposure if the distance from a person to the light source is less than the HD.
8
Label description
:
No direct exposure to the beam within the hazard distance shall be permitted, RG3 (Risk Group
:
Use of controls or adjustments or performance of procedures other than those specified herein
Label location
R5906852 F80 SERIES 21/09/2017
Advertisement
Table of Contents
