Table of Contents
Advertisement
45°
45°
Image 4-5
RCU to one of the IR sensors
4.8
Projector Address
Projector address
Address installed in the projector to be individually controlled.
Broadcast address
Projector will always execute the command coming from a RCU programmed with that broadcast address.
4.8.1
Controlling the projector
Why a projector address?
As more than one projector can be installed in a room, each projector should be separately addressable with an RCU or computer.
Therefore each projector has its own address.
Set up an individual Projector Address
The set up of a projector address can be done via the software.
Projector controlling
Every projector requires an individual address between 0 and 255.
When the address is set, the projector can be controlled now:
•
with the RCU: only for addresses between 0 and 31.
•
with a computer: for any address between 0 and 255.
Broadcast Address
Every projector has a broadcast (common) address '0' or '1'. The default address is '0'.
The choice between '0' and '1' can be selected in the GUI: "System Settings" → "Communication" →"IR Control ".
Placing new batteries in the remote control or plugging the remote to a projector via a cable will automatically
reset the address back to its default value '0'.
R5906852 F80 SERIES 21/09/2017
4. Getting Started
29
Advertisement
Table of Contents
