Table of Contents
Advertisement
4. GETTING STARTED
About this chapter
This chapter describes how to power up, control and set up your projector setup when the physical installation process is complete.
How controlling the projector ?
The projector can be controlled by the local keypad, by the remote control unit or by browser application.
Location of the local keypad ?
The local keypad is located on the right side of the projector.
Remote control functions.
This remote control includes a battery powered infrared (IR) transmitter that allows the user to control the projector remotely. This
remote control is used for source selection, control, adaptation and set up.
Other functions of the remote control are :
•
switching between stand by and operational mode.
•
switching to "pause" (blanked picture, full power for immediate restarting)
•
direct access to all connected sources.
Overview
•
Functionality overview
•
Power modes
•
Power mode transitions
•
Status overview
•
Power off projector
•
Operation in 24/7 Mode
•
Using the RCU
•
Projector Address
•
Quick setup via Direct access
4.1
Functionality overview
Local Keypad overview
1
Menu Selection.
2
Menu Activation, OK button
3
OSD On/Off.
4
Menu Back.
5
Power On/Off.
6
Touch Panel On/Off.
7
Input Selection.
8
Shutter Open/Close.
9
Test Patterns.
10
Lens Menu.
11
Touch Panel.
The Keypad gives direct access to several functions, in addition to access to the menu system.
The keypad has a back light that can be switched on and off manually. The light turns off automatically after a preselected time.
R5906852 F80 SERIES 21/09/2017
1
2
3
11
10
9
4. Getting Started
4
5
6
8
7
23
Advertisement
Table of Contents
