Table of Contents
Advertisement
4. Getting Started
4.8.2
Displaying and Programming addresses into the RCU
Displaying the Projector Address on the Screen.
1. Press the Address button to see the projector address (proximately 2 seconds).
The projector's address is displayed on the LCD status screen.
How to Program an Address into the RCU?
1. Press the Address button until the Button pressed indicator lights up continuously (proximately 5 seconds).
2. Enter the address with the digit buttons within the time the indicator lights up (also proximately 5 seconds).
Note: That address can be any value between 0 and 31.
Tip:
A few examples:
To enter address 3, press "3" digit button on the RCU to set the RCU's address to 3 and wait until the button pressed
indicator is out. Alternatively, you can also press "0" and "3". This way, he button pressed indicator goes out immediately.
To enter address 31, then press "3" and "1" on the digit button on the RCU and the button pressed indicator goes out
immediately.
4.9
Quick setup via Direct access
Quick source selection
1. Press the Input button on the remote control or local keypad.
Image 4-6
The source selection menu opens.
Image 4-7
Input selection
2. Use the arrow keys to select the desired source.
30
I
I
R5906852 F80 SERIES 21/09/2017
Advertisement
Table of Contents
