Power Off Projector; Operation In 24/7 Mode - Barco F80-Q7 User Manual

Image 4-2
4.5

Power off projector

How to Switch off the projector
1. Use the standby button, or the Power On button on the remote control, to switch off the projector.
The projector will switch to READY mode first in order to run through a cool down phase (see "Power mode transitions", page
25).
2. If ECO Standby mode is enabled in the service menu (refer to the section "GUI - system settings/Standby ECO", in User Guide)
the projector will automatically go to ECO standby mode after a time-out (default 15 minutes).
Some actions like apply a grey test pattern are done during the two minutes of the cool down phase in order
to minimize the potential effect of burn-in and increase the projector lifetime.
C
AUTION
Barco advises to keep the projector always powered and use the ECO mode for low power consumption.
How to unplug the projector
1. Follow the procedure above to Switch Off the projector.
2. Wait at least 2 minutes prior to unplug the projector by removing the power cord from the AC outlet.
C
AUTION
not adhered, projector lifetime could be degraded.
4.6

Operation in 24/7 Mode

General
When the projector is destined to be operated continuously 24 hours a day / 7 days a week, some rules must be followed to minimize
the potential effect of burn-in and increase the projector lifetime.
R5906852 F80 SERIES 21/09/2017
:
Never switch off the projector by means of unplugging mains cord or by cut down of mains power.
:
It is very important to wait few minutes before unplug the power cord. If the cool down phase is
4. Getting Started
27