8.5
Laser illumination
What can be done?
Within a certain power mode, the light output of the laser can be reduced by reducing the laser power.
How to reduce the power
1. In the main menu, select Installation → Illumination → Power.
Image 8-39
Illumination menu, Power
The actual power setting is indicated at the bottom of the Power button.
2. Use the Slider to change the power value.
Image 8-40
Laser power adjustment
8.6
Active 3D Set up
About active 3D
The projector supports active 3D, in combination with a 3D emitter and compatible battery–operated shutter glasses. The options
on the projector allow you to fine-tune the 3D settings accordingly to the specifications of the 3D emitter.
If a 3D emitter is used that radiates IR beams, the IR beams may interfere with the IR communication between
projector and the RCU. If such interference occurs, connect the RCU to the projector using the remote cable.
It is also advised to turn the IR receivers on the projector off to avoid the 3D emitter interference. To turn off
the IR receivers, see "Remote control, on/off button", page 14.
How to adjust the projector to the 3D emitter?
1. In the main menu, select Installation → 3D Set up.
Image 8-41
The 3D set up menu is displayed
Image 8-42
R5906852 F80 SERIES 21/09/2017
8. GUI – Installation
57