Installing A Remote Keyswitch; Figure 3-20: Remote Keyswitch Wiring - Honeywell VISTA-128BPT Installation And Setup Manual

Installing a Remote Keyswitch

A UL-Listed remote keyswitch, such as the ADEMCO 4146, can be used for remote arming/disarming of the burglary
portion of the system and for silencing alarms. The keyswitch can operate in only one particular partition.
U LC
Remote Arming is not a ULC Listed feature.
The keyswitch is wired across zone 7. This zone is no longer available as a protection zone. Be sure to program Zone 7
with a response type (e.g., type 10).
Operation
•
A momentary short across zone 7 arms the partition in the AWAY mode, and a short held for more than 10 seconds
arms the partition in STAY mode 1. A subsequent short disarms the partition.
•
The keyswitch LEDs indicate the partition's status (see table below).
•
A momentary short across Zone 7 silences alarm bell and keypad sounds, and disarms the system if it was armed. A
subsequent short across Zone 7 clears the alarm memory indication and resets 2-wire smoke detectors (if used).
LED Indications
Green Red
On Off
Off Off
Off On Steady
Off Slow Flash
Off Rapid Flash
The keyswitch reports as user 0, if Open/Close reporting is enabled in field ∗40.
Keyswitch Tamper Operation
The tamper switch need not be used for fire or UL Household Burglary installations. For UL Commercial Burglary
installations, the tamper switch must be wired to a zone (zone 7 in Figure 3-20).
Program that zone for Day Trouble/Night Alarm (response type 5). When the keyswitch is removed from the wall, the
tamper switch opens, causing an alarm or trouble on the zone. This also causes the control to disable keyswitch
operation until the tamper is restored and the associated partition is disarmed.
Wiring for the Remote Keyswitch
To install the ADEMCO 4146 keyswitch, perform the following steps:
Step Action
1 Connect the ADEMCO 4146 to the panel as shown in Figure 3-20.
2 If you are using the tamper, make sure it is connected to a zone.
Indication
Disarmed & Ready
Disarmed & Not Ready
Armed Away
Armed Stay
Alarm Memory
TO AUX POWER
(TERMINAL 6)
TO J7 / OUT 2
TO J7 / OUT 4
2K ELOR
+
ZONE
ZONE
TO ZONE 7 (+)
(TERMINAL 20)

Figure 3-20: Remote Keyswitch Wiring

Section 3 – Installing the Control
YELLOW WHITE
RED GREEN
(ARMED) (READY)
820 820
ohms ohms
RED BLACK
TAMPER SWITCH
(CONTACTS CLOSE WHEN
SWITCH DEPRESSED).
LOCK SWITCH
(NORMALLY OPEN)
2K ELOR
J7_keyswitch
3-19