Temporary Schedules - Honeywell VISTA-128BPT Installation And Setup Manual

Temporary Schedules

Each partition can be assigned a temporary schedule, which overrides the regular open/close schedule (and the holiday schedule). This
schedule takes effect as soon as it is programmed, and remains active for up to one week.
Only users with the authority level of manager or higher can program temporary schedules.
A temporary schedule affects only the partition from which it is entered. Temporary schedules can also be reused at later dates simply
by scrolling (pressing [#]) to the "DAYS?" prompt and activating the appropriate days. This should be considered when defining daily
time windows.
Temporary Schedule Worksheet
Partition/Windows
1
Disarm Window
Start Time
Stop Time
Arm Window
Start Time
Stop Time
2...8
Disarm Window
Start Time
Stop Time
Arm Window
Start Time
Stop Time
Temporary Schedules Programming
Enter User Code + [#] + 81 to enter this mode.
PROMPT
Mon DISARM WIND.
00:00AM 00:00AM
Mon ARM WINDOW
00:00AM 00:00AM
Tue DISARM WIND.
00:00AM 00:00AM
Days ? MTWTFSS
Hit 0-7 x x
Mon
HH:MM
HH:MM
HH:MM
HH:MM
HH:MM
HH:MM
HH:MM
HH:MM
EXPLANATION
This prompt is for entering the start and end times of the disarm (opening) window for Monday.
Upon entry of this mode, the cursor is positioned on the tens of hours digit of the start time of the disarm
window. Enter the desired hour.
Press [∗] to move to the minutes field. The minutes are entered in the same manner.
Press [∗] to move to the AM/PM position. Pressing any key in the 0-9 range toggles the AM/PM indication.
Repeat the procedure for the stop time entry.
Press [∗] to store the entries and move to the arming (closing) window for Monday.
Pressing [#] scrolls you through the prompts without making any changes.
This prompt is for entering the start and end times of the arm (closing) window for Monday.
The cursor is positioned on the tens of hours digit of the start time of the arm window. Enter the hour.
Press [∗] to move to the minutes field. The minutes are entered in the same manner.
Press [∗] to move to the AM/PM position. Pressing any key in the 0-9 range toggles the AM/PM indication.
Repeat the procedure for the stop time entry.
After the windows for that day have been completed, the system prompts for disarm and arm time windows
for the next day.
Press [#] if no changes are desired.
Repeat the procedure described above for all days of the week.
When all the windows for all the days have been completed, the system prompts for which days of the
schedule are to be activated.
This is the prompt that actually activates the temporary schedule.
To select the days to be activated, enter 1-7 (Monday = 1). An "x" appears under that day, indicating the
temporary schedule for that day is active. Entering a day's number again deactivates that day. Pressing 0
toggles all days on/off.
The temporary schedule is in effect only for the days highlighted with the letter "x" under them. As the week
progresses, the selected days are reset to the inactive state, but all other entries for the temporary schedule
remain programmed.
Press [∗] to store the entries or press [#] to exit the Temporary Schedule Entry Mode without making any
changes.
Tue Wed Thu
Section 6 – Scheduling Options
Fri Sat Sun
6-15