Daily Open/Close Schedules - Honeywell VISTA-128BPT Installation And Setup Manual

VISTA-128BPT/VISTA-250BPT Installation and Setup Guide
Start Time
Time Window
Number
1
2
3.....20
A time window must have a start and a stop time.
Time Windows Programming
Enter Scheduling Mode by entering Installer Code + [#] + [80]. The keypad displays the Time Window Programming
prompt.
PROMPT
Time Window ?
1 = YES 0 = NO 0
Time Window # ?
01-20, 00 = Quit 01
01 TIME WINDOW
00:00AM 00:00AM
Quit ?
1 = YES 0 = NO 0
Because the time windows are shared among all partitions, it is important to make sure that changing a
time window does not adversely affect desired actions in other partitions.

Daily Open/Close Schedules

Each partition can be assigned one daily open/close schedule, plus a holiday schedule. Temporary schedules are
programmed separately, using the #81 Temporary Schedule Menu Mode. To program additional open/close schedules,
see Time-Driven Events Programming later in this section for the procedure.
Open/Close Schedule Worksheet
The following worksheet is an example of the worksheet found in the Programming Guide. Write the previously defined
time window numbers for open and close for each partition.
Part Mon
Op Cl
1
2
3...8
6-6
(HH:MM)
EXPLANATION
Enter 1 at this main menu prompt to program time windows.
Enter the 2-digit time window number (01-20) to be programmed.
Press [∗] to accept the entry. Enter 00 + [∗] at the "Time Window #?" prompt to quit time window
programming and display the "Quit ?" prompt.
If you entered a time window number, the cursor is now positioned on the tens of hours digit of the start of
window entry.
Enter the desired start of window hour and press [∗]. The cursor moves to the minutes position. Enter the
desired minutes and press [∗]. Toggle the AM/PM indication by pressing any key 0-9 while the cursor is
under the A/P position and then press [∗]. Repeat this to program the stop of window entry.
When the entry is completed, the "Time Window #?" prompt is displayed again.
Enter the next time window number to be programmed and repeat the procedure.
Enter 0 at the Quit ? prompt to return to the main menu choices and continue programming.
Enter 1 to quit Scheduling Menu Mode.
Tues Wed
Op Cl Op Cl
Stop Time
(HH:MM)
Thur Fri
Op Cl Op Cl
Sat Sun
Op Cl Op Cl Op
Hol
Cl