Time-Driven Events - Honeywell VISTA-128BPT Installation And Setup Manual

VISTA-128BPT/VISTA-250BPT Installation and Setup Guide
Holiday Schedule Programming
After entering Scheduling Menu Mode, press [0] until the "Holidays ?" prompt appears.
PROMPT
Holidays ?
1 = YES 0 = NO 0
HOLIDAY NUMBER ?
01-16,00=Quit 01
01 ENTER DATE
00/00
Part ? 12345678
Hit 0-8 x x
Quit ?
1 = YES 0 = NO 0

Time-Driven Events

These schedules are used to activate outputs, bypass zones, etc. based on time. There are 20 of these schedules that may
be programmed for the system, each governed by the previously defined time windows.
The actions that can be programmed to automatically activate at set times are: relay commands, arm/disarm commands,
zone bypassing commands, and open/close access conditions.
Time-Driven Events Worksheet
The following worksheet is an example of the worksheet found in the Programming Guide. Fill out the worksheet using
the steps outlined below.
Sched
Num.
1
2
3...20
1. Enter the schedule number (01-20) and time window number (01-20), and note the day of the week the action
is desired.
2. Enter the code for the desired action and action specifier. The action codes represent the events that are to
take place when the scheduled time is reached. Each action also requires an action specifier, which defines what the
action will affect (relay, relay group, partition, zone list, user group). The action specifier varies, depending on the
type of action selected.
The following is a list of the Action Codes (desired actions) used when programming Time-Driven events. Note that
these codes are independent of the relay codes programmed during Output Programming in the #93 Menu Mode.
6-8
EXPLANATION
Enter 1 to program holiday schedules.
Enter the 2-digit holiday number (01-16) to be programmed and press [∗] to accept entry.
Enter 00 + [∗] at the "Holiday Number?" prompt to quit the holiday menus and display the "Quit ?" prompt.
The cursor is now positioned on the tens of months digit. Enter the appropriate month, then press [∗] to
proceed to the day field.
Enter the appropriate day for the holiday.
Press [∗] to accept the entry.
Holidays can be set for any partition but must always include Partition 1, as follows. Press [0] to turn all
partitions on or off, or use keys 1-8 to toggle the letter "x" under the partition to which this holiday will apply.
Press the [∗] key when all desired partitions have been assigned.
The "Holiday Number?" prompt is displayed again. Repeat the procedure for each holiday to be
programmed.
Enter 0 at the "Quit ?" prompt to return to the main menu choices and continue programming.
Enter 1 to quit Scheduling Menu Mode.
Time Days
Window M T W T
Action
F S S H Desired
Action Activation
Specifier Time