Processor Unit - Furuno FAR-2218 Installation Manual

4. Bind all cables with cable ties supplied locally (two places).
5. Check that armor of cables are lying in their respective cable slots then fasten the
cable clamp.
Microwave coaxial plug
Attach the microwave coaxial plug to the coaxial cable. See the applicable FURUNO
technical information for the procedure. Attach the coaxial cable assembly to the
transceiver unit as follows:
1. Unfasten four bolts (M6 10) to remove the dust cover from the output WG adapt-
er.
2. Fasten eight bolts (removed at step 1) to attach the flange to the transceiver unit.
3. Attach the coaxial cable to the converter of the flange.
Transceiver unit, inside view
2.7

Processor Unit

2.7.1 How to fabricate cables
For locations of cables and cores, see the sticker on the reverse side of the top cover.
(All dimensions in millimeters)
For how to connect the LAN modular plug, see "LAN cable" on page 2-4. For how to
connect the WAGO connector, see "WAGO connector" on page 2-5.
Circulator
Adapter
Cable tie Cable tie
M6×10 (4 pcs.)
Output WG
adapter
Flange
2. WIRING
Coaxial cable
Converter
: M6×20 (8 pcs.)
2-45